15.1. CELLKEY

This driver allows to exchange data and sms using an CELLKEY.

The activation of CELLKEY device on Abilis is needed to use CELLKEY. Type the following command on the CP. This will create a CTIP port which overlaps with those created with the CELLBOX.

[21:37:08] ABILIS_CPX:a dev:cellkey-1

COMMAND EXECUTED

[17:30:14] ABILIS_CPX:d ctip:501

CTIP:501 DESCR:
Act     card:CELL32-1<1>                    USER:#
Run     OPSTATE:UP        LOG:DS                               TYPE:NET-PUBLIC
        signalling:CELL                 HOLD:NO      
        VOICE-ROAMING:DISABLED     
        NUM:*                           ADDRBOOK-NUM:NUM
        CDO:#                           
        NET-MODE:AUTO     NET-SEL:AUTO       NET:
        PDN-MODE:AUTO     PDN-ROAMING:DISABLED
        PDN-APN:
        HOLD-ENABLE-LIST:#                   DIAL-IN-LIST:#

The configuration is the same of the CELLBOX.

[Tip]Tip

Interesting chapter: Section 69.17, “How to configure DATA CALL BACK using an CELL Key, calling an ISDN number”.