31.2. Example of configuration of the SMTP resource

The example below shows how to configure the SMTP resource and to relay emails using an external SMTP server:

[10:21:28] ABILIS_CPX:s p smtp local-domain:test.lan relay-net:192.168.0.0/24 server:209.85.229.109
server-user:user server-pwd:password server-auth:digest


COMMAND EXECUTED

[10:25:52] ABILIS_CPX:d p smtp

RES:Smtp - Not Saved (SAVE CONF), Not Refreshed (INIT) ------------------------
       ------------------------------------------------------------------------
Run    DESCR:Simple_Mail_Transfer_Protocol
       LOG:NO         ACT:YES              tcp-locport:25    
       SRCADD:OUT-IP                       TOS:0-N
       ses-tot:10     SES-RESERVED-IN:2    SES-RESERVED-OUT:2    
       DT:120         MAX-IP-SES:2         MAX-RCPT:100           
       IPSRC:*                             IPSRCLIST:#
       LOCAL-DOMAIN:test.lan
       HELOHOST:noname
       wdir:C:\APP\MAIL\
       max-fail-notif:50                   MB-MAXSIZE:5000
       MSG-MAXSIZE:2000                    MB-MAXMAILS:1000       STORE-MB:NO
       -- Local SMTP relay ----------------------------------------------------
       RELAY-NET:192.168.000.000/24        RELAY-IPSRCLIST:#                   
       RELAY-AUTH:DISABLED
       QUEUE-LIFE-TIME:86400               MAIL-TRY-DELAY:300  
       -- External SMTP server for relay --------------------------------------
       SERVER:209.85.229.109    
       SERVER-TCP-PORT:25                  SERVER-AUTH:DIGEST
       SERVER-USER:user
       SERVER-PWD:***
       -- SMS Gateway ---------------------------------------------------------
       SMS-GW:NO                           SMS-PERMIT:RELAY
       SMS-IP:#                            SMS-SENDER:#

This configuration allows the 192.168.0.0/24 net to use Abilis as SMTP Relay for both: local domain (test.lan) and non-local domain (through server 209.85.229.109). Use your account username and password to use the external SMTP server.

[Caution]Caution

To activate the changes made on the upper case parameters, execute the initialization command init res:smtp; while to set act the changes made on the lowercase parameters a save conf and an Abilis restart are required (i.e. With warm start command).

[Note]Note

The value of SERVER parameter can be the FQDN of external SMTP Server or it's IP address.

[Tip]Tip

Interesting chapter: Section 73.21, “How to configure CTISMS to send SMS via emails”.